Goshen Push Springs Wont Fit In Telescoping Tubes

Goshen Push Springs Wont Fit In Telescoping Tubes.

Goshen push springs are often used in telescoping tubes, but sometimes the springs just won’t fit. If you find yourself in this situation, don’t worry – there are some simple solutions. Here’s what to do.

The most common cause of a Goshen push spring not fitting in a telescoping tube is that the spring is too large for the diameter of the tube. To fix this, you’ll need to adjust the spring’s diameter. This can be done with a pair of pliers.

1. Grasp the spring with the pliers, being careful not to damage it.
2. Gently pull the spring, stretching it out until it reaches the desired diameter.
3. Check the spring’s diameter against the inside diameter of the telescoping tube to make sure it fits.
4. If the spring is still too large, repeat steps 1-3 as needed.

If the spring is too small for the telescoping tube, the solution is a bit trickier. In this case, you’ll need to build up the spring’s diameter by wrapping it with thin metal wire. Here’s what to do.

1. Wrap the thin metal wire around the spring in a spiral pattern.
2. Continue wrapping the metal wire around the spring, adding more layers until the desired diameter is reached.
3. Check the spring’s diameter against the inside diameter of the telescoping tube to make sure it fits.
4. If the spring is still too small, repeat steps 1-3 as needed.

It’s important to note that when adjusting the diameter of a Goshen push spring, you should not make it too small, as this can weaken the spring and cause it to break. Additionally, if you’re wrapping the spring with metal wire, be sure to use a wire that is thin enough to fit between the coils of the spring.

With these simple steps, you’ll be able to get your Goshen push springs to fit in telescoping tubes, no matter what their size. Good luck and happy tinkering!

Replacement of Goshen lift cable in my popup camper

, Goshen Push Springs Wont Fit In Telescoping Tubes.